new can but bike running lumpy?

[robsal0230]

Hello all just fitted a new end can as some of you already know.
I have a problem though , it seems to run a bit lumpy at high revs , anybody know what it could be?
I know all i do is ask for advice but this is all quite new to me.

Thanks.

[The Guvnor]

What bike is it mate. It may be that you need to have it set up for the end can. Its not always possible to put a race can on and get away with it !

[robsal0230]

Its a 97 cbr600f.

[fall off]

sorry to say this , i think you are going to have to spend some more money and get an dyno kit , and have it set up Properly :reading.

a good place to start looking is:- http://www.dynospeed.co.uk/index.htm he is a bit on the costly side :( but he is bloody good, known the boys from MCN and P.B to have used him.
you can go there during the day and he will put it on the dyno and tell you what you will need done for £35.00, make sure your chain and is up to it and there is enough fuel too.

good luck

[Lateshift]

I agree, if he tells you it needs a dyno kit its probably cheaper to get it all fitted as a deal somewhere else first, just for tuning it will cost you £70 down there ;)

£35 will tell you whats wrong with it, that is a fact, he is a bit of a legend with the tuning seemingly, especially where Turbo'd Hyabusas are concerned :D

[SDM]

..........a good place to start looking is:- http://www.dynospeed.co.uk/index.htm he is a bit on the costly side :( but he is bloody good, known the boys from MCN and P.B to have used him.


I've uesd these people and they are good..............:rockon :rockon