Stickers

[Unstable_Table]

Ok really stupid question i know but I am just crap at thes esort of things.
Can anyone advise the best way of putting stickers on body work without getting loads of bubbles etc......

I never seem to be able to get them on really smooth.

[SDM]

Drop Chubbs a PM or phone him up....................:clap :clap :clap

[Unstable_Table]

Cheers Kev will do.

[Tark]

you can wet the surface with soapy water first. Stick the sticker on and squeegy with a credit card or something.

[beanboy]

Unstable
my idea would be to lick your fairing all over first to get a wet surface , then holding the sticker or decal if you prefer at arms lenght in both hands run towards your bike aiming for the general area you would like to apply it.
Try to ensure a good shut of the bike at this point for max effect.

Once applied take a dry gerbal and rub it all over the surface making sure to disperse any remaining air bubbles.
Small remaining ones can be pressed out using the gerbals small claws to make tiny pin *****s in the surface to dispel the remaining air.
Once applied go over the area using buff ball or other similar rodent attached to a power drill to finish off.

Stand back and amire your work....

****e isn't it, but at least the EB stickers will still look good.:grin3:laugh1

[Tark]

nice. LOL. I like the use of animals to help achieve the desired affect!