GIXXER7
28-10-2006, 12:00 PM
Basically bought a stainless Yoshi rs3 off ebay £77
Can has been down the road and been polly filled etc, I'd like to have the rivets drilled out, cut that bit off (about 1.5 - 2 inches) and drill out the badge rivets & relocate that as the strap would be over the logo, and then have the whole lot riveted back on :laugh1 theres 4 rivets each end.
Anyone out there who can help? I'm in Basildon Essex, I'd do it myself but I have no decent tools :( Obviously I'll pay for the service, dont care if its private or a workshop.
I'd send the can back but its still quite a bargain and it just sounds too good :love1
Thanks in advance
Leon
Can has been down the road and been polly filled etc, I'd like to have the rivets drilled out, cut that bit off (about 1.5 - 2 inches) and drill out the badge rivets & relocate that as the strap would be over the logo, and then have the whole lot riveted back on :laugh1 theres 4 rivets each end.
Anyone out there who can help? I'm in Basildon Essex, I'd do it myself but I have no decent tools :( Obviously I'll pay for the service, dont care if its private or a workshop.
I'd send the can back but its still quite a bargain and it just sounds too good :love1
Thanks in advance
Leon