Abletronics absolute protect alarm system HELP!!!

[DoGbOt]

I have the above cat 1 ITM alarm system fitted to my bike only some muppet has smashed the led on the system so i dont know what function its in so can i solder a new one on?, i mainly ask as i blew the main 30amp fuse & i cant turn it on or off ( or rather its not making any sounds )after replacing the blown fuse........ & it wont let me start the bike, disconnect the system & i can start so its not a wiring problem......

Plus i dont have a manual so if anyone can help would be fantastic.... the manufacturers aint been any help at all.....

[v8-powered]

I did something similar with my Datatool.
I just measured the voltage present at the wires that connect to the LED and then purchased a new LED and the relevant resistor from an eBay seller. Soldered it on and it works fine....

As to your other problem, sounds like you may have fried it anyway......

[DoGbOt]

i did fear that it had been fried, thanks for the tip i'll try it out might show if it is dead or not...... many thanks anyhow......