PDA

View Full Version : haynes manual translation


Becky B
31-12-2007, 09:37 AM
Haynes: Rotate anticlockwise.
Translation: Clamp with molegrips then beat repeatedly with hammer anticlockwise.

Haynes: This is a snug fit.
Translation: You will skin your knuckles!

Haynes: This is a tight fit.
Translation: Not a hope in hell matey!

Haynes: As described in Chapter 7...
Translation: That'll teach you not to read through before you start, now
you are looking at scary photos of the inside of a gearbox.

Haynes: Pry...
Translation: Hammer a screwdriver into...

Haynes: Undo...
Translation: Go buy a tin of WD40 (catering size).

Haynes: Retain tiny spring...
Translation: "Jeez what was that, it nearly had my eye out"!

Haynes: Press and rotate to remove bulb...
Translation: OK - that's the glass bit off, now fetch some good pliers to
dig out the bayonet part.

Haynes: Lightly...
Translation: Start off lightly and build up till the veins on your forehead
are throbbing then re-check the manual because what you are doing now
cannot be considered "lightly".

Haynes: Weekly checks...
Translation: If it isn't broken don't fix it!

Haynes: Routine maintenance...
Translation: If it isn't broken... it's about to be!

Haynes: One spanner rating.
Translation: Your Mum could do this... so how did you manage to botch it
up?

Haynes: Two spanner rating.
Translation: Now you may think that you can do this because two is a low,
tiny, ikkle number... but you also thought that the wiring diagram was a
map of the Tokyo underground (in fact that would have been more use to
you).

Haynes: Four spanner rating.
Translation: You are seriously considering this aren't you, you pleb!

Haynes: Five spanner rating.
Translation: OK - but don't expect us to ride it afterwards!!!

Haynes: If not, you can fabricate your own special tool like this...
Translation: Hahahahahahahahahahahahahahahahahahahahahahaha!!!!

Haynes: Compress...
Translation: Squeeze with all your might, jump up and down on, swear at,
throw at the garage wall, then search for it in the dark corner of the
garage.

Haynes: Inspect...
Translation: Squint at really hard and pretend you know what you are
looking at, then declare in a loud knowing voice to your wife "Yep, as I
thought, it's going to need a new one"!

Haynes: Carefully...
Translation: You are about to cut yourself!

Haynes: Retaining nut...
Translation: Yes, that's it, that big spherical blob of rust.

Haynes: Get an assistant...
Translation: Prepare to humiliate yourself in front of someone you know.

Haynes: Turning the engine will be easier with the spark pugs removed.
Translation: However, starting the engine afterwards will be much harder.
Once that sinking feeling in the pit of your stomach has subsided, you can
start to feel deeply ashamed as you gingerly refit the spark plugs.

Haynes: Refitting is the reverse sequence to removal.
Translation: But you swear in different places.

Haynes: Prise away plastic locating pegs...
Translation: Snap off...

Haynes: Using a suitable drift...
Translation: The biggest nail in your tool box isn't a suitable drift!

Haynes: Everyday toolkit
Translation: Ensure you have an RAC Card & Mobile Phone

Haynes: Apply moderate heat...
Translation: Placing your mouth near it and huffing isn't moderate heat.

jim7
31-12-2007, 10:45 AM
:laugh1So very true!
What is it when you attempt to do a bit of home mechanics the page in the haynes is either covered in grease,chain lube,oil or the page is missing when you halfway through it!
Haynes: Routine maintenance...
Translation: If it isn't broken... it's about to be!

kasandrich
31-12-2007, 11:46 AM
Very good beckyvtr :grin1

RaceMeNSee
31-12-2007, 12:55 PM
Hahahahhahahahahahahahahah...............That is AWSOME!

ant_vaz
31-12-2007, 03:25 PM
Haynes: As described in Chapter 7...
Translation: That'll teach you not to read through before you start, now
you are looking at scary photos of the inside of a gearbox.



That'd be me to a tee. :grin2

Webby
31-12-2007, 08:41 PM
Typical lady. RTFM. Sounds a lot like most blokes too strangely. LOL. I remember asking the "boss" to read the manual for me and describoing the fault. Strange how she always found the right page with the right answer...:laugh1

Robinsonofronald
01-01-2008, 03:40 PM
Thanks for the first good laugh of the year, I'm sitting here crying.
Ever wonder why bikes (and them 4 wheeled fings) only break down in the winter.

firehorse
02-01-2008, 03:27 PM
bloody excellent. and bikes only break in winter for the same reason my boiler only ever dies at 2am on the coldest sunday of the year...